[MSIXCARBON]

Hey guys,

I had these installed on my car and tested on the dyno. The car had an ECU Tune done by Powerhaus Performance, NJ with Catless downpipes. I was very pleased with the quality of the intakes. The weave and finish are very high end and there is zero fiberglass used in the construction. Installation is definiately DIY with a few basic hand tools. It takes about 1.5 hours. These are also made in the USA. I'll support a USA made product any day :thump: Bang for the buck I think these are the best intakes on the market.

Against the stock air box with the charcoal filters in the RK Intakes picked up 38 whp. The car was also ran without the charcoal filters and the RK Intakes showed a 16 whp gain over that setup. I feel that these intakes at speed on the highway will have a clear advantage over the stock setup. Real world airflow just can't be replicated on the dyno so the potential for gains are even greater.

Here are some pictures!