Has anyone successfully ordered and installed a blendmount

[pank11]

I have sent in pictures to blend mount and it would appear that I would need BMX 2117 for the passport max 2. When I try to install my mirror stem is just to wide. I've installed them plenty of times on my other cars with no problems.

[darkz]

not sure about passport, but I use V1, so mine is BV1-2017

[pank11]

Originally Posted by darkz

not sure about passport, but I use V1, so mine is BV1-2017

Thanks for the reply! Do you know if the top and bottom of the mount touch when tightened down? It's almost like my stem is larger than 3/4

[darkz]

it fits perfectly on mine, and yes they do get touchy once tightened.

[wontonbomb]

I also have a BV1-2017 for my V1 and the fit is pretty snug - especially up against the rear view mirror housing.

Here's a photo:

[variable229]

Originally Posted by iczer34

I also have a BV1-2017 for my V1 and the fit is pretty snug - especially up against the rear view mirror housing.

Where did you tap your wire into? It looks like you used the blendmount tap kit.

[darkz]

it can be a tap kit or the hardwire kit from blend mount.

[pank11]

Thanks for all the help. I ordered the blend mount again and this time it went on in a few minutes. The last mount had to be mislabeled or something because it barely fit.