09-18-2015, 01:36 PM | #1 |
New Member
3
Rep 18
Posts |
Question regarding installation of Vorsteiner Aero lip
I received my Vorsteiner Aero lip this week and noticed that there are no installation instructions in the box (and called Vorsteiner but still haven't found answers). I see the obvious mounting holes that align with the bolts below the front bumper, but there were eleven (11) other small screws and washers included, but no mounting points, pre-driller holes, etc. There was also no included double-sided tape, so I'm hoping someone can give me some guidance on how to properly install the lip.
Any help would be greatly appreciated. Best regards, Patrick |
09-18-2015, 04:18 PM | #2 | |
Banned
56
Rep 346
Posts |
Quote:
take all the existing screws at the butom of your bumper dry fit the lip. and use the pre packed screws that came wight he lip. you have to use a screw gun to tighten them as they get loose from time to time. i drilled a few more holes to really secure the lip 2 left, 2 right, 3 middle, with self tappers to pul the lip up so theres no gap on them.. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|