11-20-2017, 10:01 PM | #1 |
Lieutenant
129
Rep 460
Posts |
Meth Setup on FBO + pure stage 2's
Was wondering what everyone thats making about 800whp is running for meth.
I bought an aquamist meth kit. How many nozzles are you guys running and where are you spraying? In the charge pipe or after the charge coolers? Also 50:50 or 100% meth?
__________________
2020 BMW m5 f90 Project gamma intake downpipes charge coolers . Awe Exhaust Pure_performance_TX stage 3 build motor e40 ABP tune snow performance meth kit
2018 x6m Built motor stage 3 tune PG downpipes |
11-21-2017, 05:49 AM | #2 |
Private First Class
73
Rep 188
Posts |
charge pipes is much easier than after the charge coolers (although not best for power) i don't bring the meth on till later when using 50/50, but when i run pure meth it responds better when sprayed earlier
|
Appreciate
0
|
11-21-2017, 02:41 PM | #3 | |
Captain
345
Rep 966
Posts |
Quote:
Sure hope you are replacing your clutches and rod bearing shells |
|
Appreciate
0
|
11-21-2017, 03:15 PM | #4 |
Lieutenant
129
Rep 460
Posts |
all done already
__________________
2020 BMW m5 f90 Project gamma intake downpipes charge coolers . Awe Exhaust Pure_performance_TX stage 3 build motor e40 ABP tune snow performance meth kit
2018 x6m Built motor stage 3 tune PG downpipes |
Appreciate
1
schnell1982345.00 |
11-21-2017, 06:27 PM | #5 |
Captain
345
Rep 966
Posts |
Nozzle guide
N20/N26: Single CM7 N54/N55 with factory turbo(s): Single CM10 or dual CM5 N54/N55 with larger hybrid turbo(s): Single CM12 or dual CM7 B48 with factory or larger turbo: Dual CM5 B58 with factory or larger turbo: Dual CM7 S55 with factory turbo(s): Dual CM5 S55 with larger hybrid turbo(s): Dual CM7 S63TU with factory or larger turbos: Dual CM10 |
Appreciate
0
|
11-21-2017, 06:29 PM | #6 |
Captain
345
Rep 966
Posts |
Above is the chart I got from Burger Motorsport website.
I have used this chart on 4 separate water/methanol injection systems I have completed. 2 - S55 Engines 2 - S63TU Engines I run 50/50 "Boost juice" from Snow Performance and for the injection site I use the BMS charge pipes with methanol bungs pre-drilled. |
Appreciate
0
|
11-22-2017, 10:20 AM | #7 |
Second Lieutenant
61
Rep 294
Posts |
I run 100% VP racing meth with dual CM14's ! I get a 60 pressure reading on the meth gauge value..
__________________
2019 F90 M5 Competition - Marina bay Blue Pearl - Executive and Bowers & Wilkins package
Gone:2013 F10 M5-DCT-Montecarlo Pearl Blue-BBMR 800 Stage 1 system 700whp+(93oct) 2004 Lamborghini Gallardo-Manual-Giallo Midas Pearl Yellow-Modified 2018 Range Rover Velar S-White |
Appreciate
0
|
12-13-2017, 03:02 PM | #8 |
Private
21
Rep 91
Posts |
What are you guys using for your meth control? any of you using JB4? if so do you ever encounter issues with over boosting when running on map 8?
__________________
2014 COMP PK M5
MSR INTAKES AMS ALPHA DOWNPIPES W/CATS JB4 w/BCM |
Appreciate
0
|
12-20-2017, 02:44 PM | #9 | |
Second Lieutenant
61
Rep 294
Posts |
Quote:
See thread; http://www.n54tech.com/forums/showthread.php?t=41272
__________________
2019 F90 M5 Competition - Marina bay Blue Pearl - Executive and Bowers & Wilkins package
Gone:2013 F10 M5-DCT-Montecarlo Pearl Blue-BBMR 800 Stage 1 system 700whp+(93oct) 2004 Lamborghini Gallardo-Manual-Giallo Midas Pearl Yellow-Modified 2018 Range Rover Velar S-White |
|
Appreciate
0
|
12-20-2017, 06:09 PM | #10 | |
F10 1/4 WR: 9.9s / 142.5mph 1/2 WR: 175.5mph
1087
Rep 1,968
Posts |
Quote:
You can turn WG adaptation off and try to customize FF/PWM... but not for the faint hearted! |
|
Appreciate
0
|
12-20-2017, 07:13 PM | #11 |
Captain
345
Rep 966
Posts |
|
Appreciate
0
|
12-20-2017, 09:41 PM | #12 |
Captain
475
Rep 608
Posts |
I'm using the snow performance stage 3 kit. I have spray starting at 6psi and full spray at 15psi. I'm not tuned for it and I always use 94oct. I'm basically using it for cooling and octane purposes. I did run 10.8@137mph with a 1.9 60ft. Before that I did 10.8@132.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|