670 Whp Beast

[Andym3100k]

Originally Posted by m6beast

Yeah I have a separate bung just for my aem lambda meter. since I don't have cats I installed it on the lower part of the DP before the resonators.
Air fuels look great .

mid 12's to 11.9's up top, as you're going through the gears.
93 octane 100% meth 6lb boost increase
100 octane 100% meth 6lb boost increase.
I use 93 on the street cause I'm not running it as hard but fill it up for the track with 100 octane just to keep things a bit cooler.
Runs strong and consistent no misfire codes like some and that's because I let the car adapt.
I feel like can raise the boost a bit but I want to make a custom intake before I do that

Can make 1 set for me for the intake? I was on 50/50 meth till I try 80/20 & the car was pulling way harder. Can't wait to put up the wideband afr reader to see what am I getting too? Shouldn't be far away from yours too.

[m6beast]

Originally Posted by Andym3100k

Can make 1 set for me for the intake? I was on 50/50 meth till I try 80/20 & the car was pulling way harder. Can't wait to put up the wideband afr reader to see what am I getting too? Shouldn't be far away from yours too.

Yeah you'll notice peformance gains especially at the end of the rpm where the car usually starts to fall off it kust keeps on pulling.

as for the intake I don't know how long before I get the intake done it just depends if we get any codes you know how sensitive these cars are. I believe the set up I've designed should be superior to any intake out there just wether or not it freaks out with MAFs. I know they have to be as perfect as factory so ill keep you in the loop. I plan to make for both the M5 and M6
G

[Andym3100k]

Originally Posted by m6beast

Yeah you'll notice peformance gains especially at the end of the rpm where the car usually starts to fall off it kust keeps on pulling.

as for the intake I don't know how long before I get the intake done it just depends if we get any codes you know how sensitive these cars are. I believe the set up I've designed should be superior to any intake out there just wether or not it freaks out with MAFs. I know they have to be as perfect as factory so ill keep you in the loop. I plan to make for both the M5 and M6
G

Perfect!

[Andym3100k]

Originally Posted by Andym3100k

Can make 1 set for me for the intake? I was on 50/50 meth till I try 80/20 & the car was pulling way harder. Can't wait to put up the wideband afr reader to see what am I getting too? Shouldn't be far away from yours too.

Hi Bro, do u still hv the graph on the afr when u r on 6psi?

[Andym3100k]

Originally Posted by badblack550xi

40whp over race gas setting... down side... possible detonation of your engine if meth stops Running... but BMS has a fail safe integrated in to it...

Hi Badblack, do u hv the dyno graph for it with n without the meth?

[badblack550xi]

Originally Posted by Andym3100k

Hi Badblack, do u hv the dyno graph for it with n without the meth?

[Andym3100k]

Originally Posted by badblack550xi

Hi Bro, this dyno was with the meth set up right? Do u have it with the overlay of one with & without meth both in the graph. Sorry I hope didn't confuse u, thanks.