06-07-2018, 02:41 PM | #46 |
Major General
2857
Rep 7,883
Posts |
By looking at your pictures, I'm also thinking that your engine's premature demise was also caused by the harsh climate where you live. I see a lot of dust and sand there. You may have had some foreign debris enter the internal engine areas and degrade the oil quality too. I'd look at doing some sort of custom air filter setup if I were you, like a double filter, or something more heavy duty, to really mitigate that sand from entering.
__________________
|
Appreciate
0
|
06-07-2018, 02:44 PM | #47 | |
Lieutenant
175
Rep 594
Posts |
Quote:
For my case need sleeves or its ok To continue my work ?
__________________
Mohamed kamal elkasaby
|
|
Appreciate
0
|
06-07-2018, 08:09 PM | #48 | ||
Captain
317
Rep 843
Posts |
Quote:
|
||
Appreciate
0
|
06-07-2018, 10:37 PM | #49 | |||
Lieutenant
175
Rep 594
Posts |
Quote:
__________________
Mohamed kamal elkasaby
|
|||
Appreciate
0
|
06-13-2018, 12:22 PM | #52 |
Lieutenant
175
Rep 594
Posts |
Special photo for you bro 😂 Titanic Ok
__________________
Mohamed kamal elkasaby
|
Appreciate
0
|
06-13-2018, 02:52 PM | #55 | |
Lieutenant
175
Rep 594
Posts |
Quote:
Pure performance, crank too
__________________
Mohamed kamal elkasaby
|
|
Appreciate
0
|
06-13-2018, 11:16 PM | #58 |
F10 1/4 WR: 9.9s / 142.5mph 1/2 WR: 175.5mph
1083
Rep 1,968
Posts |
|
Appreciate
0
|
06-13-2018, 11:19 PM | #59 |
Lieutenant
175
Rep 594
Posts |
Why ????
__________________
Mohamed kamal elkasaby
|
Appreciate
0
|
06-13-2018, 11:28 PM | #61 |
Lieutenant
175
Rep 594
Posts |
Please all i need support and advice
My car now little scratches on walls like picture i post Crank which bearing spun on cyl 3,6 I measured by micro meter All by 53.580 But that one from crank 53.486 3 bent rods What i should go with good offer (not expensive ) I can rebuild it in my service center in egypt Please i want to take a good decision without regret I contact Pure performance And they can send me The machines center will recheck for walls if they can try to clear scratches without clearance going out of range But please i want support too
__________________
Mohamed kamal elkasaby
|
Appreciate
0
|
07-04-2018, 06:30 PM | #65 |
Lieutenant
175
Rep 594
Posts |
Updates
__________________
Mohamed kamal elkasaby
|
Appreciate
2
gary_F10M51.50 Phil@BPC463.00 |
07-09-2018, 06:18 AM | #66 |
Captain
474
Rep 607
Posts |
Where did you get the parts from?
__________________
G80 Comp, Hcp custom e50, 9.69@141
F90 Comp, Hcp custom e40 meth, 9.76@143, 174ml/h 1/2ml 60-130 5.53 F10 M5, HCP Tune ,BM3, 10:8@137, 166.05 1/2ml. Ig @mcc420 |
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|