| 10-09-2016, 09:12 AM | #1 |
|
Second Lieutenant
 42
Rep 216
Posts |
Help: Passenger Restraint Error
While trying to tap a wire to install my Valentine 1 radar I unplugged one of the cords for the restraint and even though it is plugged back in it shows an error now. Anyone have any idea why?
|
| 10-09-2016, 11:08 AM | #2 | |
|
Hide! My wife's coming!
812
Rep 2,816
Posts |
Quote:
__________________
*** SOLD *** 2013 BMW M5 | Space Grey | MSR Stage 3 Tune | Catless Downpipes | MSR Intake and Charge Pipes | MSR Exhaust (Prototype) | Vorsteiner Rear Diffuser | RW Carbon Front Lip | RW Carbon Trunk Spoiler| Vorsteiner VS-310 Forged Wheels | Escort 9500CI w/Laser Jammers
|
|
|
Appreciate
0
|
| 10-09-2016, 05:03 PM | #3 |
|
Second Lieutenant
42
Rep 216
Posts |
Thanks - did some researching and it looks like it trips if you unplug the wire at all. Tried resetting with ODO but didn't work. Not sure how else to reset.
|
|
Appreciate
0
|
| 10-10-2016, 09:51 AM | #4 |
|
Lieutenant
57
Rep 451
Posts |
Use Tool32, included with EDIABAS.
Clear Fault Codes: Assuming the fault condition no longer exists, to clear the fault code. 1) Launch C:\EDIABAS\Bin\TOOL32.EXE 2) Hit F3 3) Load C:\EDIABAS\Ecu\F01.PRG 4) In the "Select Job: F01" window, select FS_LOESCHEN_FUNKTIONAL 5) Hit F5 6) "Results" window should show "JOB_STATUS = OKAY" Note: fs_lesen_funktional only read fault codes, FS_LOESCHEN_FUNKTIONAL will delete it. |
|
Appreciate
0
|
Post Reply |
| Bookmarks |
| Thread Tools | Search this Thread |
|
|
