03-13-2017, 02:58 PM | #1 |
F10 1/4 WR: 9.9s / 142.5mph 1/2 WR: 175.5mph
1087
Rep 1,968
Posts |
FS: s63tu engine + Gaskets/Bearings/Timing Chain
Folks. I am selling the long-block I had purchased for a rebuild. What I am including are: 1. s63tu long block assembly - Includes the entire rotating assembly intact - No manifolds, HPFP or anything that bolts on the outside 2. Cylinder Head Gasket Kit - OEM Part # 11122327854 - GetBMWParts price is $723 3. Short-block Gasket Kit - OEM Part # 11112250202 - GetBMWParts price is $256 4. Timing Chains x 2 - OEM Part # 11317605195 / 11317605193 GetBMWParts price is $90 each 5. Timing Chain Guide x 2 - OEM Part # 11317594909 / 11317594899 - GetBMWParts price is $38 each 6. Calico Coating Bearing Set (Rods, Crank, Main) by VAC Motorsports - These are OEM bearings coated for high-temp / low friction - These cost me $1250 Description: All the gasket kits, timing chains, guides and bearings are NEW and UNOPENED from the condition I purchased them. I purchased the s63tu from a dealership that swapped the motor out for someone. It is off a 2014 M5 with 22K miles. The motor runs but has a ticking noise - presumably a rod/piston likely needs to be replaced as that's the typical failure mode on this motor. I never opened it up so can't say which cylinder per se. This is intended for a REBUILD. These are my cost #'s. A running s63tu long-block is upwards of $12K and complete engines are easily $15-$17K as a comparison. Motor will be on a pallet and all the parts boxes will be included in a single shipment. Shipping is NOT included but PM me and we can work something out if needed. Last edited by allmotor_2000; 03-24-2017 at 10:22 AM.. |
Post Reply |
Bookmarks |
|
|