View Single Post
      04-16-2024, 12:29 AM   #53
M_Bimmer
Major
M_Bimmer's Avatar
742
Rep
1,021
Posts

Drives: F02 B7, G12 B7, G07 XB7, 911
Join Date: May 2020
Location: Left Coast

iTrader: (0)

Quote:
Originally Posted by Staszek View Post
Can you help with the wiring for Rad On for an F06 M6. I assuming that I can run motor power, LED power and ground right to the three wires for the cigarette lighter (powerport).
The "RAD_ON" signal is on pin 13, Connector A42*1B, which is the 40-pin, black connector shown in the figure label "2", below.

And if this pin is not populated, you can get a socket crimp it on to a 20 gauge wire and run it up to your B&O center speaker. If unpopulated, you will need to use BimmerCode or ESYS to code the "RAD_ON" to function. It might already be active and populated if you have active sound.

You can use any power source that runs off the Terminal 30B power rail, such as Fuse F119 in the Glovebox Fusebox, or the cigarette light, which too runs off the Terminal 30B power rail.
Attached Images
  
Appreciate 1
SCD-1983615.50