Quote:
Originally Posted by BalSingh
I want to attempt, but really I would get someone else to do it…problem is getting it off, will have to either take the bumper off or drop the car with them.
Cannot find a like for like replacement, it was on the car when I bought it.
|
With what it would cost for someone else to do it, it may be more practical to get another new one of different make. Mine is ABS knowing if something like this should happen it can be inexpensively replaced using the special screws supplied being removed easily and another wing one slotted in, just it needs two of you with some duck tape to temporarily locate it after the corner pieces are installed to position the main wing to insert those screws into the locating corner piece holes.
I have two small hydraulic jacks which made the job much easier lifting the car from the front jacking points using the round slotted rubber jack cushions and removing the serrated jacking ends from the jacks so its a flat contact.
There are instructions on the internet of how others fit them also.