Quote:
Originally Posted by ddiimmaa
from what I read and found, it's a changing of pinout on the headlight plug, and coding. If you reach out to Marius, tagged in the thread he ca. pull the wiring diagram for your car, and I can give you my vin so you can compare them and see where the difference is. Based on what has been stated before its easier than running new wiring and taking dash trunk etc apart. but you still have to remove front bumper and wheel well covers to get new lights in and out..
"From hallogen headlight to LCI Xenon (not AHL)
2 - 2
3 - 3
6 - 6
9 - 5
10 - 8
11 - 7
12 - 1
then add extra GND to pin 4
After that take out 2 pins from FRM and join them together into one pin (Y connection)
(pin 4 - A58*2b) and (pin 6 - A58*1B) to FRM pin 41 (A58*2B)"
there's a few other threads on it, so doable and definitely simpler and close to half the cost of going to LED..
|
Has anyone done this DiY ? I think is the retrofit I need for a pair of Aftermarket LED without AHL.
