Quote:
Originally Posted by rockyfeller
Method 2:
If for some reason you don't see these parameters on expert mode for your car then try the following alternative method for coding :
Coding for 8S4 (VLD - works for both HID Xenons and LED adaptive lights):
Front Electronic Module > Expert Mode >
3073 LaMaster1 > LUT_FLC_FORWARDLIGHTING_Y > 9C,9C,9C (Both)
3073 LaMaster1 > C_AFS_ENA > Enable (Both)
Coding for 5AP (GFHB - works for LED adaptive lights ONLY):
Front Electronic Module > Expert Mode >
3073 LaMaster1 > C_HBA_ENA > Enable (Both)
3073 LaMaster1 > C_HBA_GRHB_ENA > Highway_Standby_AFS
3073 LaMaster1 > C_HBA_ADAPT_SHUT_ENA > Enable
|
Sorry to reboot this thread! I gave this a go last night on my 2015 F80 and got a little confused, so ended up just backing off until I got some clarification here.
Car has LEDs (5AC, 5AP, 8S4), but when I got into Expert Mode on Bimmercode, I had two options for each parameter and was
not able to check both options as required per instructions above. Some values read 20, 25 or 30, so again, unsure on which to choose.
3073 LaMaster1 > LUT_FLC_FORWARDLIGHTING_Y > 9C,9C,9C (Both)
I had two options for F020_mit_AFS 0x9C 0x9C 0x9C, but could only choose one.
3073 LaMaster1 > C_AFS_ENA > Enable (Both)
This showed F020_enable and F030_enable.
3073 LaMaster1 > C_HBA_ENA > Enable (Both)
This showed F020_enable and F030_enable.
3073 LaMaster1 > C_HBA_GRHB_ENA > Highway_Standby_AFS
3073 LaMaster1 > C_HBA_ADAPT_SHUT_ENA > Enable
These were both fine and had one option to choose from.
Hoping for some insight from you coding gurus!