Quote:
Originally Posted by M5theonlyone
Warm the engine for 5 minutes at tick over from cold then proceed not to take it over 2500 rpm until oil temp normal. For running-in you can use the revs but not under load, that is not with full throttle.As the mileage increases add more revs with just enough not to stress the engine and continue to the run-in end point then you can gradually start pushing the engine more 
How was the engine repaired or did you have a replacement short block.. |
Thanks for that information. I have been letting the car sit on cold start for a a few mins before driving off, I have been very steady with the car, i have already done about 300 miles and not been over 3/4rpm yet.
It was a replacement block.