Quote:
Originally Posted by Pikey Motorsports
Quote:
Originally Posted by theinfamousdrew
I've been doing a good bit of research on intakes the past couple weeks.
After reading dozens of posts I think I'm going to tackle building a set on my own.
My design will be based off popular front mount systems.
We'll see how this goes.  |
I was going to do the same but couldn’t be bothered with getting the maf housing scaled up |
Yea I realize that's going to be a challenge. My plan is to use the stock flex joint and do my best to mirror the exact location of the stock flange.
I've been taking all sorts of measurements hopefully to get it just right.