01-31-2024, 06:27 AM | #1 |
Lieutenant
67
Rep 580
Posts
Drives: 2016 M5 Comp. Ed.
Join Date: Nov 2011
Location: London
|
How do you remove this plastic trim from the side? The usual pry tool doesn’t seem to be working or I’m not trying hard enough. Any help? And is it possible to run a cable under the trim, along the fender and into the cabin (behind the dash)?
__________________
Garage:
2012 520d (retired) 2016 M5 Comp. Ed. 2020 Porsche 911 Carrera S (retired) 2023 X5 xDrive45e Last edited by darrko; 01-31-2024 at 10:51 AM.. |
01-31-2024, 09:09 AM | #2 |
Private First Class
221
Rep 178
Posts |
Did you pry up the little plastic pin in the center of the clip before you tried prying up the whole clip? Once the center pin is up it should come out easily. As for the wire I'm sure there is an access hole somewhere I'd imagine.
|
Appreciate
1
darrko66.50 |
01-31-2024, 10:42 AM | #3 |
Lieutenant
67
Rep 580
Posts
Drives: 2016 M5 Comp. Ed.
Join Date: Nov 2011
Location: London
|
Aaah I was trying to pry the whole clip! Will try the pin first, thanks.
__________________
Garage:
2012 520d (retired) 2016 M5 Comp. Ed. 2020 Porsche 911 Carrera S (retired) 2023 X5 xDrive45e |
Appreciate
1
Mitchell431220.50 |
01-31-2024, 06:22 PM | #5 |
Private
105
Rep 68
Posts |
I ran an OBD2 cable through the firewall on the other side of the engine bay, not sure about this side. I would just pull the trim and look for a rubber grommet, etc. I followed the instructions on the jb4 website for the other side. If you scroll down through these instructions, you can get the idea. Good luck!
https://www.jb4tuned.com/instruction...b4_install.pdf |
Appreciate
1
darrko66.50 |
02-01-2024, 06:53 AM | #6 | |
Lieutenant
67
Rep 580
Posts
Drives: 2016 M5 Comp. Ed.
Join Date: Nov 2011
Location: London
|
Quote:
__________________
Garage:
2012 520d (retired) 2016 M5 Comp. Ed. 2020 Porsche 911 Carrera S (retired) 2023 X5 xDrive45e |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|