04-14-2014, 07:50 AM | #1 |
Brigadier General
386
Rep 3,450
Posts |
URGENT TURNER WONT FIT 3D Design Diffuser
So,
as my turner exhaust and 3d diffuser were about to be installed in the same time, it turns out that both doesn't go good, the exhaust touches the diffuser, any solution guys? Thanks,
__________________
"Well, there's a straight-six engine at the front, a manual gearbox in the middle and drive goes to the back. That's Page 1, Chapter 1 from the petrosexual handbook" - JC
|
04-14-2014, 10:06 AM | #2 |
Captain
105
Rep 806
Posts |
I would think that it wouldn't take much to move the exhaust a hair so it isn't touching the diffuser. Have a exhaust shop cut the hangers loose move the exhaust and reweld the hangers or heat the turner pipe up a bit and bend them so they wont touch.
__________________
2014 ///M5 CP Tanzanite Blue/Cohiba - 11.15 @ 128.8 & 1.84 60' (2150' DA) - BPM Tune - MSR Intake - SSP DCT - SS DPs & HFC Mid Pipes/X-Over - E Race Muffs - 19" MT DRs... On to a new home.
|
Appreciate
0
|
04-14-2014, 11:14 AM | #3 |
Brigadier General
386
Rep 3,450
Posts |
Alright will be working on it tomorrow!
__________________
"Well, there's a straight-six engine at the front, a manual gearbox in the middle and drive goes to the back. That's Page 1, Chapter 1 from the petrosexual handbook" - JC
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|