06-15-2022, 09:36 PM | #1 |
Enlisted Member
27
Rep 44
Posts |
Swapping DME sides?
Guys,
I am getting a weird issue with car which seems to be affecting passenger side bank of injectors. I wanted to try and figure if maybe the DME on that side is fried or something. Am I able to swap my DME across banks? Like put the left one on the right side and vice versa or are they different in some way? Thanks! |
06-15-2022, 11:15 PM | #3 |
New Member
17
Rep 18
Posts |
Very good chance that your DME is bad according to this tsb
https://static.nhtsa.gov/odi/tsbs/20...47602-9999.pdf |
Appreciate
0
|
06-16-2022, 12:39 AM | #4 |
Second Lieutenant
86
Rep 242
Posts |
No you cannot switch them after being programmed.
I would say check the harness first as some corrosion might cause that (First check if its seated correctly the do a continuity test to the injectors harness if all is fine, check if the DME is supplying voltage if no voltage then replace your DME). I had the same issue with my charge coolers pump, replaced them but the issue still there finally I decided to de-pin the terminal and here was the surprise. Last edited by M6Roar; 06-16-2022 at 01:12 AM.. |
Appreciate
1
Denver_M516.50 |
06-26-2022, 08:39 PM | #5 |
3387
Rep 7,541
Posts |
You can swap the sides.
__________________
-----| Like us on Facebook | Instagram || Tuning Information | Remote Coding |----- ----Visit us at www.BPMSport.com - Emotion. Driven. | Toll Free: (888) 557-5133---- |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|