Unknown issue from dkg Transimision

[wheelpro]

Originally Posted by bavarianmotors

i have seen f10 m5 with Fault in hydraulic control after installing ssp clutch and could't do the transmissions adaption ,its always terminated specially in gear learn procedure

then we realized the issue is from the other garage installed 2.2mm ring instead of the 1.6mm ring

u need to check and fitted the clutch again it may be similar issue

I know this step well
I have something wrong
Unknown fault
When switched from p to n
Clutche Pressure 1 high
Mechatronic from p to n. No action from it
But pressure sensor read pressure high
I changed basket, clutches, oil pump , 3 mechatronic , another transmission
Really very strange
May be control unit give wrong order ?

[wheelpro]

Originally Posted by SSPKris

What was the suction filter blocked with?
What type of debris?

Kris please can you check my last update

[SSPKris]

Send me the clutch for examination. This is a free service from us. This will eliminate the any possibilities of a clutch issue.

SSP

[SSPKris]

Originally Posted by wheelpro

Kris please can you check my last update

Is this the same car you have been working on for 2 years now?

SSP

[wheelpro]

Originally Posted by SSPKris

Is this the same car you have been working on for 2 years now?

SSP

Yes but i changed dct before
With new ssp clutches

[SSPKris]

Pull the basket from the transmission and send it to me. I can pressure check it and make sure everything is installed correctly.....
There may be internal clutch basket seal problems that you are not aware of.

SSP

[wheelpro]

Originally Posted by SSPKris

Pull the basket from the transmission and send it to me. I can pressure check it and make sure everything is installed correctly.....
There may be internal clutch basket seal problems that you are not aware of.

SSP

can you send me address please

[SSPKris]

PM Sent

[wheelpro]

Originally Posted by SSPKris

PM Sent

Nothing