05-13-2019, 02:40 PM | #1 |
Private
11
Rep 69
Posts |
Need a DIY to drop the front subframe.
So small back story. I purchased a 2013 M5 that came with a unique set of problems on the driver side, no worries I figured I have worked on my E39 540i enough this should be easy... I have replaced damn near every component intercooler, bent tensioner and my master cylinder. Now I'm replacing the driverside sensor wire harness and I have changed everything except the two knock sensors at the bottom of the block. I cant reach them with 11", 12" or 16" needle nose plyers. I even tried fabing a tool to reach them with no luck. I have searched the forums with no luck. Any help would be greatly appreciated.
|
05-14-2019, 01:44 PM | #2 | |
Lieutenant
385
Rep 533
Posts |
Quote:
__________________
1972 Bavaria> 1973 3.0Si> 2013 328i> 2009 E92 M3> 2013 F10 M5: Singapore Gray over Sakhir Orange, Executive, Driving Assistance, B&O
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|