10-28-2020, 11:46 AM | #1 |
General
59842
Rep 19,510
Posts |
OBD 2
Just used my OBD 2 for first time to kill a CEL,followed instructions from internet didn't get the code but it said I had to switch engine off and have ignition on only to cancel any fault codes.If it comes back on again i shall mess around with it for a code but I had just changed fuel to Shell v-p for first time, so that may be it.
*Also on another thread there was a warning about using Carly with a phone,worth reading. |
Post Reply |
Bookmarks |
|
|