Swapping DME sides?

[turboslut]

Guys,

I am getting a weird issue with car which seems to be affecting passenger side bank of injectors. I wanted to try and figure if maybe the DME on that side is fried or something. Am I able to swap my DME across banks? Like put the left one on the right side and vice versa or are they different in some way?

Thanks!

[turboslut]

These are the codes I am getting

[Denver_M5]

Very good chance that your DME is bad according to this tsb

https://static.nhtsa.gov/odi/tsbs/20...47602-9999.pdf

[M6Roar]

No you cannot switch them after being programmed.

I would say check the harness first as some corrosion might cause that (First check if its seated correctly the do a continuity test to the injectors harness if all is fine, check if the DME is supplying voltage if no voltage then replace your DME).

I had the same issue with my charge coolers pump, replaced them but the issue still there finally I decided to de-pin the terminal and here was the surprise.

[BPMSport]

You can swap the sides.

[GRIMA]

Yes you can swap the sides no problem

I did it when I had the problem when one side of the engine was not working

Came out ECU
And you need PROPER coding