07-13-2020, 02:56 PM | #1 |
New Member
23
Rep 25
Posts |
M Performance v2 install issue
So I decided to purchase and install the M Performance v2 steering wheel. The install seemed pretty straight forward. I transferred everything over to the new wheel without issue but when I went to reinstall and turned on the car I turned the steering wheel and the horn turns on and won’t turn off till I disconnect the battery. I feel like i may have installed the air bag incorrectly because I can only unlatch the left side now. I’ve spent the last hour trying to unlatch the right side of the airbag but it seems like the latch isn’t where it’s suppose to be. Sorry if this is not the correct place for this discussion I am new to the forums. Any help is much appreciated.
|
07-13-2020, 04:55 PM | #3 |
Major General
3274
Rep 6,723
Posts |
Try disconnecting the battery again.
Then snap the airbag back in Then try to unhook the airbag starting with the side that gave you trouble (RH) Check to make sure all the wires are clipped back in their proper routing and clear of the airbag release holes and retention clips. Snap the airbag back in and make sure both sides snap back into place. |
Appreciate
0
|
07-13-2020, 05:10 PM | #4 | |
New Member
23
Rep 25
Posts |
Quote:
|
|
Appreciate
0
|
07-13-2020, 05:25 PM | #5 |
Major General
3274
Rep 6,723
Posts |
My only major gripe with that video is that he doesn’t have DCT (I know, not his fault) so was lost a bit on how to disconnect the paddle connectors as they are pretty tight.
Maybe a bit closer up and not as fast forwarded would have helped. Dunno. I’ve done two of these now. I swapped my wheel for a V2 and then swapped my old wheel onto my sons 335i M Sport with paddles/lane departure/heated steering. |
Appreciate
0
|
07-14-2020, 09:36 AM | #6 | |
New Member
23
Rep 25
Posts |
Quote:
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|